Installation file - Global Drive Oscilloscope GDO V1.3.0.2
Description The Global Drive Oscilloscope GDO diagnostics software is a software oscilloscope for the ECS controllers, the 9300 ServoPLC and the Drive PLC. So far, the GDO has been delivered together with GDC or the DDS and could be optionally installed.
The following software products / device descriptions and communication drivers are installed automatically: • DriveServer V1.3.6.0 (protected Lenze version) • CAN communication software V2.2.12.0
System requirements • Microsoft Windows 2000 as of SP4 + roll-up pack1 / XP 32-bit as of SP3 / Windows 7 32-bit • IBM-compatible PC as of Intel® Pentium® 333 processor • Min. 128 MB RAM • 250 MB free hard disk capacity • Min. resolution of 1024 x 768 pixels with 256 displayable colours • Mouse • Free slots/interfaces corresponding to the requirements of the fieldbus connection module to be used
Software installation How to install GDO V1.3.0.2:
Unpack the 'GDO_V13.zip' file in any directory on your PC.
Exit all GDO versions if you have already started them.
Start the unpacked 'setup.exe' file and follow the installation instructions.
Check, if you can extend Global Drive Oscilloscope with the latest device data update by new device-specific files for Lenze target system.
Note: GDO V1.3.0.2 is installed as an independent software.
Note: If the download does not start, please observe the notes contained in the Online Help.
The software is supplied to the user as described in this document. Any risks resulting from its quality or use remain the responsibility of the user. The user must provide all safety measures protecting against possible maloperation. We do not take any liability for direct or indirect damage, e. g. profit loss, order loss or any loss regarding business.
