Direct positioning, control bit Ctrl1.Bit15 no longer required (V2.0 onwards)

Function extension:
It is no longer necessary to set control bit Ctrl1.Bit15 in order for a 'Direct positioning' to function in a profile. From ECS Posi&Shaft V2.0 onwards, it is sufficient to select a corresponding profile mode under C3095/x for direct positioning.

In which products/versions is it included?
ECS Posi&Shaft V2.0 onwards

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/200901318/1/
Meta data
Taxonomy: ECSxA application , ECSxE power supply module , ECSxK capacitor module , ECSxM motion , ECSxP position and shaft , ECSxS speed and torque , ECS servo inverters
AKB-ID: 200901318
Last update: 2023/09/09
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Contact form