Port 9410 in case of GCI parameter channel

Question:
Which Ethernet port has to be applied in order to access and read/write the Lenze codes of Lenze inverter by means of GCI protocol?

Answer:

The ethernet port 9410 has to use, so that you are able to get a communication via Lenze GCI protokol with the following drives:

9400 Servoinverter with Ethernet NRT
9400 Servoinverter with Profinet I/O
8400 StateLineC with Profinet I/O
8400 HighLineC with Profinet I/O
8400 TopLineC with Profinet I/O
8400 protec with Profinet I/
all i-series device with Ethernet, Profinet I/O or EthernetIP

The ports indicated in the KHB Ethernet, port 1200 and 9400, cannot be used!

KHB := Manual (Communication)

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/200708538/1/

Meta data

Taxonomy: Ethernet MXI E94AYCEN , 9400 HighLine servo inverters , 9400 Servo PLC servo inverters , 9400 StateLine servo inverters , 9400 servo inverters , 8400 protec EMS frequency inverters , 8400 protec HighLine frequency inverters , 8400 protec StateLine frequency inverters , 8400 protec frequency inverters , 8400 BaseLine frequency inverters , 8400 HighLine frequency inverters , 8400 StateLine frequency inverters , 8400 TopLine frequency inverters , 8400 frequency inverters , PROFINET MXI E94AYCER
AKB-ID: 200708538
Last update: 2024/01/11
Category: FAQ, Tips and Tricks

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.