Value display of application codes with decimal digits

Question:
What has to be done in order to display values of user codes with decimal codes?

Answer:
User-codes of PLC target systems can be displayed by Lenze parameter software programs (e. g. Global Drive Control, DDS Parameter Monitor), as well as by Lenze operating units.

The attached pdf document shows how up to four decimal codes can be generated.


URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/200605934/1/
Meta data
Taxonomy: HMI Designer , Global Drive PLC Developer Studio
AKB-ID: 200605934
Last update: 2024/01/11
Category: FAQ, Tips and Tricks

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.

Further information

Contact form