Error LED of the c430 is on, no connection can be established (fixed with V1.13)
Corrected from:
Cabinet Controller c430 V1.13
Behavior of the new version:
Booting the controller without SD card has no influence in establishing a connection with the controller.
Description of the behavior:
The error LED of the controller lights up red. It is not possible to establish a connection with the controller.
Conditions under which the behavior occurs:
If the controller is booted without an SD card, the behavior occurs after a total of 10 boot processes.
Affected products:
Cabinet Controller c430 from V1.11
Short-term measures, Recommendations, Rating:
Only switch on the controller c430 when an SD card is inserted in the controller.
Insert the SD card from another controller c430. Then restart the controller. After an internal boot process, the controller will restart normally. ATTENTION: The SD card must remain in the device otherwise the same behavior will occur again after 10 boot processes.
Using an empty SD card or pressing the reset button on the controller does not remove the functional restriction.
