Description The Drive PLC Developer Studio is a development environment, which allows you standardised programming of the Lenze PLC devices with different editors of the IEC 61131-3
This installation file extends DDS by the following
two components to the IP20 I/O system:
• LenzeIOSytemV0102.lib
Function library for DDS is used for connecting the IP20 Lenze I/O system to the Lenze PLC devices. This library considers function extensions, which have been implemented in the I/O system with the firmware version V1.1.
• SW_DDS_FBLib_IOSystem_v1-3_DE.pdf
Documentation of the function block library LenzeIOSystemV0102.lib.
Information about function extensions and fault elimination can be taken from the
difference description.
Software: With the installation following Lenze software products are extended by the described components:
• Global Drive PLC Developer Studio V1.4
• Global Drive PLC Developer Studio V2.x
Hardware: After installation following Lenze products will be supported by the above-mentioned software products:
• EPM-T110 V1.0, V1.1
• EPM-T830 V1.0, V1.1
• EPM-T831 V1.0, V1.1
• EPM-T832 V1.0, V1.1
• EPM-T833 V1.0, V1.1
System requirements • Microsoft® Windows® 98/Me, Windows NT® 4.0 (from Service Pack 5), Windows 2000 (from Service Pack 2) or Windows XP
• IBM-compatible PC with Intel®Pentium®-90 processor
• 32 MB RAM
• 10 MB free hard disk capacity
• Pointer instrument (mouse, trackball etc.)
• Global Drive PLC Developer Studio V1.x or V2.x is required to be installed in your PC.
Software installation Install the DDS function library for IP20 Lenze I/O system firmware V1.1:
1. Unpack the ZIP-file
DDS_function library_IOSystemIP20_V11.zip and store the data locally in your PC.
2. Start the program
setup_DDS_IOsystem_V0100.exe and follow the installation instructions. The function library will be installed in the subdirectories of DDS to the corresponding target systems.
Download DDS_Funktionsbibliothek_IOSystemIP20_V11.ZIP (4.4MB): DDS function library for IP20 I/O system firmware V1.1
