L_TT1P: Drive errors cannot be acknowledged (corrected from V3.15.0)

Corrected from:
L_TT1P_TechnologyModules_LM (V3.15.0.32)

Response of the new version:

Drive errors that are no longer pending (dwDriveError) can be acknowledged with xReset.

What happens?

Drive errors that are no longer pending (dwDriveError) cannot be acknowledged with xReset.

When does this behaviour occur?

An i700 axis reports an error (e.g. motor temperature too high)
After that, the technology module is activated (xEnabled = TRUE) and the controller is enabled (xRegulatorOn = TRUE)
The technology module indicates an error (xError = TRUE)
An error reset is performed (Important step; xReset = TRUE) --> Since the error is still pending, the error message does not disappear
Now, the error is reset in the controller (e.g. motor temperature is no longer too high)
Another error reset is performed (xReset = TRUE) --> After this, the error message can no longer be acknowledged.

Which products are affected?
All technology modules from the L_TT1P_TechnologyModules_LM library (all versions)

Short-term measures:

None

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201700130/1/

Meta data

Taxonomy: TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Register Control , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201700130
Last update: 2023/09/09
Category: Release notes

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.