L_TT1P_RegisterControl: lrSensorToolDistance parameter is missing in the visualisation template (corrected from V3.12)

Corrected from:
L_TT1P_TechnologyModules_LM V3.12.0.9

Response of the new version:

The lrSensorToolDistance parameter has been added to the visualisation of the L_TT1P_RegisterControlBase and L_TT1P_RegisterControlState technology module. The parameter can thus be changed via the visualisation.

What happens?
The "lrSensorToolDistance" parameter is missing in the corresponding visualisation template (section "Parameters") of the RegisterControl technology module (Base and State).

When does this behaviour occur?

The behaviour occurs if the lrSensorToolDistance parameter shall be changed via the integrated visualisation.

Which produts are affected?
L_TT1P_RegisterControl function block from the L_TT1P_TechnologyModules_LM library (V3.10.0.8 and higher)

Short-term measures:

The parameter can only be selected and changed from the PLC application.

Evaluation/recommendation:

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201500620/1/

Meta data

Taxonomy: TM Register Control , TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201500620
Last update: 2023/09/09
Category: Release notes

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.