Which products are affected?ESPLV11XA0FC1 (Prepared Solution Flying Saw V1.1)
Eliminated function restriction
When the following files have been replaced, the acceleration time of the 'flying saw' can again be parameterised by means of code C3012.
Users working with the parameterisable variant only have to exchange the *.bin file. If the Prepared Solution is adapted by means of DDS, the *.lib file must be exchanged.
Files to be exchanged:
Library file:
FlyingSawControlV010100.lib
Installed file dated: 2nd April 2008
File to be exchanged dated: 15th September 2008
Binary file for the ECSxA target system:
FlyingSaw_ECS_V010100.BIN
Installed file dated: 24th April 2008
File to be exchanged dated: 15th September 2008
Binary file for the ServoPLC target system
FlyingSaw_SPLC_V010100.BIN
Installed file dated: 24th April 2008
File to be exchanged dated: 15th September 2008
The files are copied to the following target directory in the Explorer:
The library file is copied to the following target directories:
C:\Program files\Lenze\DDS_P_2_30\9300SPLCv60000\Libraries
C:\Program files\Lenze\DDS_P_2_30\9300SPLCv70000\Libraries
C:\Program files\Lenze\DDS_P_2_30\ECSxAv80000\Libraries
The binary files are copied to the following target directories:
C:\Program files\Lenze\L-force Loader_4_0\bin\PreparedSolution
Note:
Before the files are copied to the target directory, rename the old files.
E.g.: FlyingSaw_SPLC_V010100_old.BIN
The renamed file does not get a new time stamp in the Explorer.
