L_TT1P_Winder: Wrong ramp is used for deceleration (corrected from V3.13)

Corrected from:
L_TT1P_TechnologyModules_LM (V3.13.0.7 and higher)

Response of the new version:

The lrSyncLineDec ramp is used for deceleration.

What happens?

The ramp set in scPar.lrSyncLineAcc is used for deceleration.

The ramp set in scPar.lrSyncLineDec should be used.

When does this behaviour occur?

The technology module is decelerated from the line speed -> xSyncLineVel = FALSE;

Which products are affected?
L_TT1P_Winder technology module from the L_TT1P_TechnologyModules_LM library (V3.12.0.9 and higher)

Short-term measures:

Set the scPar.lrSyncLineAcc ramp to the the value to be used for deceleration.

The changed scPar.lrSyncLineAcc ramp becomes immediately effective.

Evaluation/recommendations:

The faulty behaviour is only relevant if different ramps are to be used for acceleration and deceleration. If the above-described short-term measure is observed, the function is provided.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201600130/1/

Meta data

Taxonomy: TM Winder Dancer-controlled , TM Winder Tension-controlled , TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Register Control , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , FAST Motion Lib L_TT1P_LM
AKB-ID: 201600130
Last update: 2023/09/09
Category: Release notes

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.