L_TT1P_CrossCutter: lrSetOverspeedScaled input is set to 0 via the visualisation (corrected from V3.17.0)

Corrected from:
Library:  L_TT1P_TechnologyModules_LM  from  V03.17.0.47
                      (update via Easy Package Manager)
 
Response of the new version:
The value of the lrSetOverspeedScaled input is never changed by the technology module.
 
What happens?
The lrSetOverspeedScaled input is set to 0.
 
When does this behaviour occur?
The technology module is operated via the visualisation provided in the library.
A value other than 0 is set for the lrSetOverspeedScaled input.
During operation, the technology module reports an error.
The error is acknowledged with xResetError = TRUE.
 
Which products are affected?
L_TT1P_CrossCutter from the L_TT1P_TechnologyModules_LM library (V3.16.0.62 and higher)
Short-term measures:
None

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201800076/1/
Meta data
Taxonomy: TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Register Control , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201800076
Last update: 2023/09/09
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Contact form