L_TT1P_ElectricalShaftVelHigh: OP01_lrOffset displays no values (corrected from V3.17.0)

Corrected from:
Library:  L_TT1P_TechnologyModules_LM from V03.17.0.47  
                 (Update via Easy Package Manager)
Response of the new version:
The OP01_lrOffset variable (from the scSignalFlow structure) displays valid values in a clutched-in state.
 
What happens?
OP01_lrOffset variable (scSignalFlow structure) permanently displays 'zero'.
 
When does this behaviour occur?
The technology module is in a clutched-in state (xSynchronised = TRUE).
A velocity offset is connected at the lrSetOffset input.
 
Which products are affected?
L_TT1P_ElectricalShaftVelHigh from the L_TT1P_TechnologyModules_LM library (V3.16.0.62 and higher)
 
Short-term measures:
The status of the OP01_lrOffset variable is also displayed via the lrOffset output. The technology module output can thus be directly used to read out the current offset.
 
Evaluation/recommendations:
If the above short-term measure is taken into account, the desired status can be displayed via the offset.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201800072/1/
Meta data
Taxonomy: TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Register Control , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201800072
Last update: 2023/09/09
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Contact form