L_TT1P_RegisterControl: Incorrect mark error calculation (corrected from V3.14.0)

Corrected from:
L_TT1P_TechnologyModules_LM (V3.14.0.21)
 
Response of the new version:
The calculated mark errors are correct for all marks that have occurred.
 
What happens?
The calculated mark error is incorrect.
 
When does this behaviour occur?
The behaviour occurs sporadically. It cannot be avoided by parameter settings.
 
Which products are affected?
L_TT1P_RegisterControl function block from the L_TT1P_TechnologyModules_LM library (V3.10.0.8 and higher)
 
Short-term measures:
None

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201500902/1/
Meta data
Taxonomy: TM Register Control , TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201500902
Last update: 2023/09/09
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Contact form