L_TT1P_TablePositioning: Profile is not executed if lrFinalVelocity <> 0 (corrected from V3.12)

Corrected from:
L_TT1P_TechnologyModules_LM library V3.12.0.9

Response of the new version:
When linking profiles (both profiles with final speed), the second profile will no longer be skipped, but executed correctly.

What happens?
A linked positioning profile is skipped.

When does this behaviour occur?

The behaviour occurs if two linked profiles are of the same positioning type (e.g. absolute) and have a final speed.

Which products are affected?
L_TT1P_TablePositioningBase function block from the L_TT1P_TechnologyModules_LM library (V3.10.0.8 and higher)

Short-term measures:

If possible, use different positioning modes.

Evaluation/recommendations:

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201500756/1/

Meta data

Taxonomy: TM Table Positioning , TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Register Control , TM Smart Track , TM StackerCrane , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201500756
Last update: 2023/09/09
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.