L_TT1P_CrossCutter: Additional travel process with xHoldInparkPosition when cross cutter is already in the parking position.

What happens?

The cross cutter leaves the parking position. After one revolution, the parking position is approached again.

When does this behaviour occur?

The cross cutter is in the parking position. xHoldInparkPosition is triggered.

Which products are affected?

L_TT1P_CrossCutter in the L_TT1P_TechnologyModules_LM library (V3.14.2.58 and higher)

Short-term measures:

None

No change is planned for this behavior.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201700222/1/

Meta data

Taxonomy: TM Basic Motion , TM Cross Cutter , TM Electrical Shaft Position , TM Electrical Shaft Velocity , TM Flex Cam , TM Flying Saw , TM Magic Track , TM Pick and Place , TM Register Control , TM Smart Track , TM StackerCrane , TM Table Positioning , TM Temperature Control , TM Track Pick and Place , TM Traverser , TM Virtual Master , TM Winder Dancer-controlled , TM Winder Tension-controlled , FAST Motion Lib L_TT1P_LM
AKB-ID: 201700222
Last update: 2023/09/09
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.