Brake output X25, new status bit Stat1.Bit7 (brake open) for brake control (as of V3.0)

Function extension:
The current switching status of the holding brake (at X25) is now displayd in status word 1 of the new status bit Stat1.Bit7. It can therefore be used as feedback to the master control:
  • Stat1.Bit7 = 1: Brake open (relay output (X25) triggered, relay contact closed)
  • Stat1.Bit7 = 0: Brake closed (relay output (X25) not triggered, relay contact open)

In the 'brake logic deactivated' (C4020 = 0) state, the brake remains permanently released and the status bit remains permanently set (Stat1.Bit7=1).
If the brake logic is activated (C4020=1, C4020=2) the status bit Stat1.Bit7 is switched in accordance with the current signal status at the brake relay output X25.

See also AKB article: 200905104 'Brake to be operated via control bit Ctrl1.Bit2, C4020 brake logic mode'.

Included in which products/versions?
ECS Motion as of V3.0
(Operating software from V8.3 onwards required)

Published in Service Message No. 2010/xx

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/201000435/1/
Meta data
Taxonomy: ECSxA application , ECSxE power supply module , ECSxK capacitor module , ECSxM motion , ECSxP position and shaft , ECSxS speed and torque , ECS servo inverters
AKB-ID: 201000435
Last update: 2023/09/14
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Formulario de contacto