Node address of the system bus interface X14 (CANaux) can also be set via DIP switch

Which products are affected?
ECS axis module V8.0

Function description
Dependent on the position of DIP switch 1 the node address of the system bus interface X14 (CANaux) can now also be set in addition to the node address of the system bus interface X4 by means of the DIP switches 2…7. If DIP switch 1 is set to ON both system bus interfaces have the same node address. The baud rate for system bus interface X14 must still be set via code.

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/200801880/1/
Meta data
Taxonomy: ECSxA application , ECSxE power supply module , ECSxK capacitor module , ECSxM motion , ECSxP position and shaft , ECSxS speed and torque , ECS servo inverters
AKB-ID: 200801880
Last update: 2023/09/08
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Formulario de contacto