Fixed as of:
Behavior of the new version:
Description of behavior:
After in a PLC Designer project under Coupler_I_O_modules , theParameters tab isnot visible. As a result, it is not possible to configure the I/O module via the parameter interface.
Conditions under which the behavior occurs:
I/O modules are added to the backplane bus for the first time in a PLC Designer project.
Affected products:
PLC Designer version 4.1 and later
Short-term measures, recommendations, assessment:
Save and close your PLC project. Reopening it will restore the Parameter tab will become visible. Alternatively, you can also find the parameters for the I/O modules in the controller's parameter list under Module configuration.
[Automatic Translation]
