L_TS2P_SyncAndCorrection: TM remains in xSynchronised status, although xEnableOperation = FALSE is set (corrected from V3.32.0)

Corrected from:
L_TS2P_TechModulesSynchronizingCamming (from V3.32.0)

(Update via Easy Package Manager)

Behavior of the new version:

If the TM ‘SyncAndCorrection’ is used to set the controller enable (EnableOperation) to FALSE in the synchronised state, the ‘Synchronised’ status is FALSE

Description of the behavior:

If the TM ‘SyncAndCorrection’ is used to set the controller enable (EnableOperation) to FALSE in the synchronised state, the ‘Synchronised’ status is TRUE

Conditions under which the behavior occurs

Motion_Axis Parameter 0x500A:107 = 0->NoResponse

Affected products:

L_TS2P_TechModulesSynchronizingCamming

Short-term measure, recommendations, evaluation:

Set xSyncIn= FALSE if xEnableOperation = FALSE

URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/202400400/1/

Meta data

Taxonomy: Lib L_TC2P_TechModulesCoordinatedMotionBasic , Lib L_TX2P_TechModulesPickAndPlace , Lib L_CM1P_ControlModules , Lib L_TB1P_TechnologyBasics , Lib L_TB2P_TechModulesBasic , Lib L_TF2P_TechModulesFollowingPositioning , Lib L_TP2P_TechModulesProcessFunctions , Lib L_TS2P_TechModulesSynchronizingCamming , L_TV2P_TechModulesStackerCrane , Lib L_TW2P_TechModulesWindingTraversing , FAST Motion Modules V2
AKB-ID: 202400400
Last update: 2025/05/14
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.