Error message 'Error writing parameter 0x500A:054' during parameter set download (fixed as of V3.20.1)
Corrected from:
Cabinet Controller c300 V3.20.1
Cabinet Controller 3200C V3.20.1
Panel Controller p300 V3.20.1
Panel Controller p500 V3.20.1
Response of the new version:
The EASY Starter can be used to transfer a parameter set via a Lenze controller as a gateway to an i950 servo inverter without errors.
What happens?
When downloading a parameter set to an i950 servo inverter, the error message appears:
Error writing parameter 0x500A:054
When does the behaviour occur?
The error message occurs when an attempt is made with the EASY Starter to carry out a parameter set download via a Lenze controller as a gateway to an i950 servo inverter.
Which products are affected?
Cabinet Controller c300
Cabinet Controller 3200C
Panel Controller p300
Panel Controller p500
Short-term measures:
After downloading the parameter set, check the affected parameter 0x500A:054 (= Following error: Monitoring enabled) and set it again if necessary. Then save the parameter set in the Servo Inverter i950.
Evaluation / recommendations:
When transferring a parameter set to an i950 servo inverter through a Lenze controller, the parameter 0x500A:054 cannot be written to. An error message appears. The parameter must be subsequently changed and saved in a power-failure-proof manner.
Taxonomy:
Controller 3221 C
,
Controller 3231 C
,
Controller 3241 C
,
Controller 3251 C
,
Controller 3200 C
,
Controller p500
,
Controller c300
,
Controller p300
AKB-ID:
202100012
Last update:
2023/09/09
Category:
Informations sur la version
Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
