Homing, zero pulse of the additional encoder not observed
Which products are affected?
ECS axis module ECSxx series, operating software ≤ V6.6
What happens?
During homing it is always the home position of the resolver (speed feedback) which is evaluated. This is also the case if an encoder is set as position feedback in addition. However, in this case homing should be executed to the home position of the encoder.
When does the problem occur?
If the following encoder configuration is selected:
Speed feedback (C0495): Resolver
Position feedback (C0490): Encoder
Possible diagnostics?
None.
Short-term measures/recommendations?
None.
Evaluation:
In this case a workaround is not possible. Therefore, another homing mode must be selected during commissioning.
Taxonomy:
ECSxA application
,
ECSxE power supply module
,
ECSxK capacitor module
,
ECSxM motion
,
ECSxP position and shaft
,
ECSxS speed and torque
,
ECS servo inverters
AKB-ID:
200500054
Last update:
2023/09/08
Category:
Informations sur la version
Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
