Which products are affected?
ECS axis module ECSxx series, operating software ≤ V6.6
What happens?
GDC indicates an error message when executing the reset node command (C0358) via GDC. The error is caused by an undefined response telegram of the ECS.
When does the problem occur?
When executing the reset node command (C0358) via GDC.
Possible diagnostics?
Error message in GDC.
Short-term measures/recommendations?
None.
Evaluation:
The communication connection to the drive may get lost since the reset node is executed. This may happen if e. g. the node address or baud rate has been changed. In this case a following write command cannot be executed via GDC (e. g.: save the parameter set, C0003 = 1). The communication must be re-established.
Taxonomy:
ECSxA application
,
ECSxE power supply module
,
ECSxK capacitor module
,
ECSxM motion
,
ECSxP position and shaft
,
ECSxS speed and torque
,
ECS servo inverters
AKB-ID:
200500048
Last update:
2023/09/08
Category:
Informations sur la version
Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
