Direct positioning, control bit Ctrl1.Bit15 no longer required (V2.0 onwards)
Function extension:
It is no longer necessary to set control bit Ctrl1.Bit15 in order for a 'Direct positioning' to function in a profile. From ECS Posi&Shaft V2.0 onwards, it is sufficient to select a corresponding profile mode under C3095/x for direct positioning.
In which products/versions is it included?
ECS Posi&Shaft V2.0 onwards
Taxonomy:
ECSxA application
,
ECSxE power supply module
,
ECSxK capacitor module
,
ECSxM motion
,
ECSxP position and shaft
,
ECSxS speed and torque
,
ECS servo inverters
AKB-ID:
200901318
Last update:
2023/09/09
Category:
Informations sur la version
Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
