Eliminated from:
L_TT1P_TechnologyModules_LM (from V3.16.0.62)
Behaviour of new version:
If a touch probe event occurs outside of the parameterized mark window, it is ignored. There is no position correction.
What happens?
A mark is corrected. The cut is triggered at a wrong position.
When does this behaviour occur?
The behaviour occurs when the RegisterControl technology module is used with touch probe in a window and touch-probe events occur outside the window.
Which products are affected?
L_TT1P_RegisterControl in the L_TT1P_TechnologyModules_LM library (from V3.15.1.4)
Short-term measures:
Do not use any touch-probe window or only pass on touch-probe events to the RegisterControl technology module (xMarkReceive) if they are inside the window.
