Virtual axis: Parameter values are not saved in the PLC project of an i950 (corrected from V4.0.1)

Corrected from:
PLC Designer V4.0.1
Behavior of the new version:
Parameter values changed in the PLC project are also saved when the project is saved.

Description of behavior:
Changed parameter values for the 'VirtualMaster_Axis' object are not saved with the PLC project.

Conditions under which the behavior occurs:
When creating a PLC project for a Servo Inverter i950 with the object 'VirtualMaster_Axis' under 'VirtualAxes' in the device tree.

Affected products:
PLC Designer from V3.28

Short-term measures, Recommendations, Rating:
Install the latest version of PLC Designer (V4.0.1 or higher).

[Automatic Translation]


URL for linking this AKB article: https://www.lenze.com/en-de/go/akb/202500109/1/
Meta data
Taxonomy: PLC Designer V3.x , PLC Designer V4.x
AKB-ID: 202500109
Last update: 2026/01/22
Category: Version Informations

Lenze reserves the right to change information on this page at any time. Any liability for the accuracy of the information is excluded.
Contact form