Error message when connection is lost (corrected with V1.15)
Corrected with:
PLC Designer 4.0
Behavior of the new version; If the connection is lost, PLC Designer does not display the error message 'Assertion Failed'.
Description of the behavior: The PLC Designer displays the error message 'Assertion Failed'58;
OnExecuteServiceSyncronously got called for an incompatible channel (!= IChannel4)
Under what conditions does this behavior occur? The error message may occur sporadically if the connection between PLC Designer and the Lenze controller is interrupted.
Affected products; PLC Designer from V3.26
Short-term measures/Assessment/Recommendations;
Ignore the error message. Once the connection has been reestablished, you can go online again without any problems.
