URL:
/es-mx/go/akb/200704954/1
¨Replace component¨ cannot be realised by means of the CAN-module (elimination)
Which products are affected?
L-force Engineer V1.5 with…
URL:
/es-mx/go/akb/200704952/1
Tab error causes the Engineer to be aborted (elimination)
Which products are affected?
L-force Engineer V1.5 with installed Service Pack…
URL:
/es-mx/go/akb/200704950/1
After program upload reduction errors can occur (elimination)
Which products are affected?
L-force Engineer V1.5 with installed Service…
URL:
/es-mx/go/akb/200704560/1
Parameter setting dialogs of various FBs are available again in the FB-Editor (elimination)
Which products are affected?
In the FB-Editor…
URL:
/es-mx/go/akb/200704558/1
Corrupt project when the ¨Save as¨ function is used (elimination)
Which products are affected?
L-force Engineer HighLevel 1.5
L-force…
URL:
/es-mx/go/akb/200704680/1
Parameter set file cannot be loaded into 9300 standard servo devices (elimination)
Which products are affected?
Global Drive Loader V3.0…
URL:
/es-mx/go/akb/200704444/1
The tension controller cannot be activated independently via C3160 (elimination)
Which products are affected?
TensionControl template…
URL:
/es-mx/go/akb/200704443/1
Parallel write access of the visualisation to g_DCTRL_bCInh1_b (elimination)
Which products are affected?
TensionControl template V3.0,…
URL:
/es-mx/go/akb/200704441/1
Parallel write access of the visualisation to g_DCTRL_bTripReset (elimination)
Which products are affected?
TensionControl template V3.0,…
URL:
/es-mx/go/akb/200704438/1
The displayed angle of rotation of the reel (dnPos_p) varies very strongly (elimination)
Which products are affected?
Function block…
URL:
/es-mx/go/akb/200704190/1
SDO gateway does not work (C0370) (remedied from V3.0)
Remedied from:
ECS power supply module ECSxE series, operating software V3.0…
URL:
/es-mx/go/akb/200704189/1
Prolonged charging time after power supply enable in case of non-rigid and noise sensitive systems (remedied from V3.0)
Remedied from:…
URL:
/es-mx/go/akb/200704188/1
Sporadical LP1 mains fault in case of mains frequencies of 60 Hz and mixed up mains phases (remedied from V3.0)
Remedied from:
ECS…