Full version of Lenze DriveServer and Lenze DriveServer S7

Product:

- ESP-DRS1 Lenze DriveServer (DriveServer.zip)   
- ESP-DRS1-S7 Lenze DriveServer with S7 bus server (DriveServer S7.zip)
 
Download:
 
If the download does not start, please follow the notes in the online help.
 
Software installation:
How to install the product:
1.  Download the corresponding zip file and unpack it.
2.  Run the setups with respect to the the STEP order.
 
System requirements:

 

• Microsoft® Windows® 2000 (service pack 4), XP (32-bit) and Windows® 7 (32-bit)
• Microsoft® Internet Explorer version 6.0 or higher
• IBM®-compatible PC with Intel® Pentium® processor with at least 750 MHz
• 512 MB RAM
• 200 MB free hard disk capacity
• Pointer device (mouse, trackball, etc.)
• Free slots/interfaces according to the requirements of the fieldbus interface module to be used
 
Notes:
After unpacking the corresponding zip file, please run the setups with respect to the STEP order.
When installing DriveServer V 1.1.2.0 under Windows 7 (32-bit), an OPCenum error message may occur.
This error message may be ignored. Continue running the setup.
 
Back