Current full version of the Drive PLC Developer Studio Professional V2.4 inclusive Service Pack 1

Description
The software development environment for the PLC of the drive. The 9300 Servo PLC and Drive PLC are programmed using the Drive PLC Developer Studio (DDS) integrated software development environment.

System requirements

  • Microsoft® XP 32 Bit as of SP3 / Windows® 7 (32 Bit and 64 Bit)
  • IBM-compatible PC with Intel® Pentium® processor as of 333 MHz
  • 128 MB RAM
  • 250 MB free hard disk capacity
  • Minimum resolution of 1024 x 768 pixels with 256 displayable colours
  • Mouse
  • Free slots / interfaces according to the requirements of the fieldbus interface module to be used

Note
With the installation routine you can execute the following installations:

  • full verison DDS Professional V2.4 (input of a licence number is necessary)
  • update DDS Professional from V2.x to V2.4 (installation of a previous DDS version is necessary)

Information on function extensions and fault eliminations are provided in the following difference descriptions:

Software installation
Depending on the current status of your PC there are two different ways to execute the installation:

  1. Previous version V2.4 is installed: Installation of Service Pack 1
    Proceed as follows to install the Service Pack for DDS Professional V2.4:
    1. Save the file DDS_V24SP1.zip (64.2 MB) in any directory on your PC.
    2. Unpack the ZIP file into any directory on your PC.
    3. Close all DSD versions if you have already started them.
    4. Start the setup.exe file and follow the installation instructions.
  2. In all other cases
    Proceed as follows to install the full version of DDS Basic V2.4:
    1. Save the file DDS_Professional_V24a.zip (73.4 MB) in any directory on your PC.
    2. Unpack the ZIP file ino any directory on your PC.
    3. Close all DSD versions if you have already started them.
    4. tart the setup.exe progam and follow the installation instructions.
      Install the current Service Pack afterwards:
    5. Save the file DDS_V24SP1.zip (64.2 MB) in any directory on your PC.
    6. Unpack the ZIP file into any directory on your PC.
    7. Close all DSD versions if you have already started them.
    8. Start the setup.exe file and follow the installation instructions.

Note:
If the download does not start use the context menu (right mouse button) to save the file. Please observe the notes in the Onlinehilfe.

Back